PIR Motion Sensor

Application à la détection de mouvement : camera de surveillance, économie d'énergie, ...

SEN-08630

• http://www.sparkfun.com/products/8630
• http://bildr.org/2011/06/pir_arduino/
• http://dx.com/p/ir-infrared-motion-detection-sensor-module-dc-5v-20v-139624

SKU 139624 (HC-SR501)

• http://dx.com/p/ir-infrared-motion-detection-sensor-module-dc-5v-20v-139624
• http://blog.roman-mueller.ch/index.php/2013/01/26/hc-sr501-passive-infrared-sensor-with-arduino/
• http://zygzax.com/2012/11/17/sensor-de-movimiento-pir-hc-sr501/?lang=en

The HC-SR501 Module has three connection pins: +5v, OUT(3.3v) and GND; and two variable resistors for calibration (Ch1 and RL2).

Ch1: With this resistor, we can set the time that the output of the sensor will be active. One of the main limitations of this module is that the minimum time is about 3s. If we change the variable resistor to another of 100K, we can decrease the minimum time to approximately 0.5 s.

RL2: This variable resistor allows us to set the detection range, which could vary betwen 3-7m.

    Dimension: 3.2cm x 2.4cm x 1.8cm (approx)
    Infrared sensor with control circuit board
    The sensitivity and holding time can be adjusted
    Working Voltage Range: DC 4.5V- 20V
    Current drain:<60uA
    Voltage Output: High/Low level signal:3.3V TTL output
    Detection distance: 3--7M(can be adjusted)
    Detection range: <140°
    Delay time: 5-200S(can be adjusted, default 5s +-3%)
    Blockade time: 2.5 S (default)
    Trigger: L: Non-repeatable trigger  H: Repeat Trigger (default)
    Work temperature:-20-+80°C
    Trigger Method: L unrepeatable trigger / H repeatable trigger